- IMU Sensor (LSM9DS1)
- Temperature & Humidity (BME280)
- Light Sensor (TSL25911)
- Air Quality Sensor (CCS811)
- Mic (SPH0645LM4H via I2S & SPV1840LR5H via analog)
- Magnetic Sensor (AH1884)
- GPIO Expander (SX1509)
- Analog Expander (MAX11609)
- GPS Module
- Neopixel LED
- Buzzer
- RTC
- I2C Grove Connector
- GPIO Grove Connector
- Analog Grove Connector
- Can use Rain and Wind Sensor
Atilze LoRa Shield
Based on Gemtek GL6509 LoRaWAN module
- Use Malaysia LoRa frequency (919-923 MHz)
- 32 bit MCU
- AT command based module
- High receiver sensitivity down to -137.5 dBm
- Adjustable TX power up to 19.15 dBm
- Support FSK, GFSK, LoRa modulation
- LoRa node class A
This Atilze LoRa Shield also,
- Compatible with Arduino/Genuino UNO, CT-UNO, CT-ARM, Arduino/Genuino Mega.
- U.FL to SMA connector
- Pre-provisioned with Atilze Fabrick platform
- RX and TX LED indicator
- Include 1x 915 MHZ SMA antenna
- UART selectors for software UART / hardware UART / PC to GL6509.
- 3 Grove connectors
- Suitable for low power wireless network application
- ESP32 as Microcontroller
- Built-in USB to TTL
- 2×20 Pin Header Breakout
- LED matrix 7×7 controlled by charlieplexing method using IS31FL3731
- Built-in Neopixel LED
- Provide capacitive touch area
- Reset and flash button
- Micro SD card slot
- Power: LiPo battery via JST connector, or 5V~6V via Micro USB connector
- Built-in Photo Transistor
- I2C and GPIO grove connector
- Compatible I2C 2.54mm pin header for extended OLED